Filter
Top Products
EXAMPLE NETWORKS
26 CyberSWITCH
The only other item on the Device ISDN Line Protocol Menu that this type of device needs is the
maximum data rate. We will accept the default value of 128,000 bps. No changes are required.
Return to the Device Table Menu.
At the Device Table Menu, press 4 to enter the authentication information needed for this device.
The authentication information needed for each device depends on the device type.
For device “Mike Mann,” we opt to configure a bridge Ethernet address (000123456789), we will
assign a bridge password (JXF30), and configure a first and second calling line Id. After the device
authentication has been entered for device “Mike Mann,” the screen will appear as follows:
Next, enter the device information for Pat Smith. This device is also an HDLC bridge, and is
configured using the same type of authentication as device Mike Mann, except we will configure
no password for device Pat Smith. Enter 003456789000 for the bridge Ethernet address,
13135556789 for the first calling line Id, and 13135559876 for the second calling line Id.
The following screen will be displayed after information for both devices in our network has been
entered:
Device Authentication Menu: (Device = "Mike Mann")
PPP:
1) PAP Password ""
2) CHAP Secret ""
3) Outbound Authentication ENABLED
4) User Level Authentication DISABLED
IP Host (RFC 1294):
5) IP Host Id ""
HDLC Bridge:
6) Bridge Ethernet Address "000123456789"
7) Bridge Password "JXF30"
ISDN:
8) Calling Line Id(s) "13135551212"
"13135552121"
Select function from above or <RET> for previous menu:
CURRENT DEVICE TABLE (Sorted by Device Name in Ascending ASCII Order)
id Device Name
----------------------------
1 "Mike Mann"
2 "Pat Smith"
(1) Add, (2) Change, (3) Delete, (4) Display a Device or press <RET> for previous menu?