Cabletron Systems 150 Switch User Manual


 
EXAMPLE NETWORKS
70 CyberSWITCH
Press 5 to enter the first dial out number. A phone number must be defined for each remote device
that will be dialed. This number includes any prefix digits, area codes, or extensions as required to
dial the destination device. It is possible to specify two phone numbers for the remote device. For
this example, we will only be entering one phone number, 913135553232, which is the phone
number for SITE2.
After all of the ISDN configuration has been completed, the ISDN Configuration Menu will be
displayed as follows:
Return to the Device Table Menu.
At the Device Table Menu, press 4 to enter the authentication information needed for this device.
The authentication information needed for each device depends on the device type.
For device “SITE2”, because we will be configuring CHAP security, we opt to configure a CHAP
secret (ikcd98s). After the secret has been entered, the Device Authentication Configuration Menu
will appear as follows:
Again, return to the Device Table Menu.
Next, press 5 to enter the IP Information for device SITE2. SITE2 uses an unnumbered link, so we
will enter the IP address as 0.0.0.0.
Device ISDN Menu: (Device = "SITE2")
1) ISDN Line Protocol "PPP (Point to Point Protocol)"
2) Base Data Rate "64000 bps"
3) Initial Data Rate "64000 bps"
4) Maximum Data Rate "384000 bps"
5) Dial Out Phone Number(s) "913135553232"
6) Subaddress ""
7) Profile Name "Default_Profile"
8) H0 Call Support DISABLED
Select function from above or <RET> for previous menu?
Device Authentication Menu: (Device = "SITE2")
PPP:
1) PAP Password ""
2) CHAP Secret "ikcd98s"
3) Outbound Authentication ENABLED
4) User Level Authentication DISABLED
IP Host (RFC 1294):
5) IP Host Id ""
HDLC Bridge:
6) Bridge Ethernet Address ""
7) Bridge Password ""
ISDN:
8) Calling Line Id(s) ""
Select function from above or <RET> for previous menu: