Filter
Top Products
Chapter 5: Local Management
5-66 6H128-08 and 6H129-08 User’s Guide
5.18.3 Setting (Enabling or Disabling) the Port Status
To set the status of an interface (port), proceed as follows:
1. Use the arrow keys to highlight the Status field of the port.
2. Use the SPACE bar to toggle to either ENABLED or DISABLED.
3. Use the arrow keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message “SAVED OK” is displayed.
5.19 ETHERNET INTERFACE CONFIGURATION
Access the Ethernet Interface Configuration screen from the Module
Configuration Menu screen by using the arrow keys to highlight the
ETHERNET INTERFACE CONFIGURATION menu item and
pressing ENTER. The Ethernet Interface Configuration screen displays.
NOTE
Disabling the port status of a backplane connection will block
the module from passing user traffic to the applicable module
slot in the 6C105 chassis. SNMP and other management traffic
(e.g., ping and Telnet traffic), however, will still pass via the
backplane to the applicable module slot.