Filter
Top Products
Chapter 4: The System Level Screen
4-4 ESX-1320/ESX-1380 Local Management Guide
4.3 SETTING THE SYSTEM TIME
To set the system clock, perform the following steps:
1. Use the arrow keys to highlight the System Time field.
2. Enter the time in a 24-hour format, HH:MM:SS.
3. Press ENTER to set the system clock.
4. Use the arrow keys to highlight the SAVE command field at the
bottom of the screen and press ENTER.
If the time entered was a valid format, the Event Message field at the
top of the screen displays “SAVED OK”. If the entry was not valid,
Local Management does not alter the current value and refreshes the
System Time field with the previous value.
NOTE
When entering the time in the system time field, you do not
need to add separators between hours, minutes, and seconds,
as long as each entry uses two decimal numbers. For example,
to set the time to 6:45
A.M., type “064500” in the System Time
field.