Filter
Top Products
Chapter 7 Sending Faxes 7-5
Sending Faxes
Sending Methods
This section explains the two main sending methods: Memory sending and Manual
sending via the handset.
Memory Sending
Memory sending is a quick and easy way to send a document. As the machine scans
the first page of a multipage document into its memory, it begins calling the other party
and transmitting the information even as the remaining pages are being scanned.
Since your machine is multitasking, you can even scan a document into memory while
performing other tasks.
Your machine has enough memory to store up to approximately 350 pages* (fewer if
the document contains many graphics or particularly dense text).
Follow this procedure to send a document using memory sending:
1 Load the document, face down in the
ADF (1 p. 4-3).
•To adjust the resolution and contrast,
(Currently used memory)
see pp. 7-2, 7-3.
•You may be unable to send if the
memory used (shown in the LCD) is (Standby to scan)
close to
100%. Use manual sending
via the handset instead (1
p. 7-6).
2 Dial the other party’s fax number.
•For dialing methods, see p. 7-4.
• If you enter the wrong number, press
Stop/Reset, then enter the correct
number.
• If you are connected to a PBX and need
to first dial an outside line access
number (“9”, for example), add a pause
after that number by pressing
Pause
(1 p. 9-2).
TEL= 9p76xxxxx
DOCUMENT READY
MEMORY USED 0%
*Based on ITU-T No. 1 Chart, standard mode.