Canon MP810 All in One Printer User Manual


 
74 Troubleshooting
LCD Cannot Be Seen At All
An Unintended Language Is Displayed on the LCD
Cannot Install the MP Drivers
Cause Action
Cannot see the display on the LCD.
z If the POWER lamp is off
The machine is not powered on. Connect the power cord and press the ON/
OFF button. The machine will power on and the LCD will display a message.
z If the POWER lamp is lit
The LCD may be in the screen-saver mode. On the Operation Panel, press a
button other than the ON/OFF button.
Cause Action
The language you want to be displayed
is not selected.
Select the language you want to be displayed according to the following
procedure.
(1)Press the HOME button. Wait for about 5 seconds, select , and then
press the OK button.
(2)Press the ] button to select , then press the OK button.
(3)Press the } button four times, then press the OK button.
If the Bluetooth unit is connected to the machine, press the } button five
times, and then press the OK button.
(4)Press the { or } button to select the language you want to be displayed,
then press the OK button.
Cause Action
Unable to proceed beyond the Printer
Connection screen.
If you were unable to proceed beyond the Printer Connection screen, follow
the procedure below to reinstall the MP Drivers.
(1)Click Cancel on the Printer Connection screen.
(2)Click Start Over on the Installation Failure screen.
(3)Click Back on the screen that appears next.
(4)Click Exit on the Welcome screen, then remove the CD-ROM.
(5)Turn the machine off.
(6)Restart the computer.
(7)Make sure you have no application software running, including anti-virus
software.
(8)Follow the procedure described in the Easy Setup Instructions to reinstall the
MP Drivers.