Filter
Top Products
89Troubleshooting
Error No.: 1700 Is Displayed
Error No.: 1851 Is Displayed
Error No.: 1856 Is Displayed
Error No.: 2001 Is Displayed
Error No.: 2500 Is Displayed
Cause Action
The ink absorber is almost full. The machine has a built-in ink absorber to hold the ink used during Print Head
Cleaning, for example.
This error message indicates that the ink absorber is nearly full.
Press the OK button to cancel the error so you can continue printing.
However, because printing is disabled once the ink absorber becomes
completely full and until the ink absorber is replaced, you are recommended to
contact a Canon service representative as early as possible. (You will need to
replace a particular part of the machine.)
Cause Action
Inner Cover was open when you
started printing.
Close Inner Cover, press the OK button on the machine. Printing will start again.
Cause Action
Inner Cover was opened while printing
was in progress.
Close the Inner Cover, then press the OK button on the machine.
A page of print data being sent at the time of the error will be erased, so print
that page again.
Cause Action
No response from connected digital
camera or video camcorder. /
Connected digital camera or video
camcorder connected is not compatible
with this machine.
Disconnect the cable connecting the machine and the device, and then
reconnect it.
Depending on the model or brand of your device, you may have to select a
PictBridge-compliant print mode on the device before connecting it to the
machine. You may also have to turn on the camera or select Play mode
manually after connecting the device to the machine.
Perform necessary operations according your device’s instruction manual
before reconnecting it to the machine.
If the error is still unresolved, there is a possibility that you are using a digital
camera or digital video camcorder that is not supported by this machine. Use a
digital camera or digital video camcorder compatible with this machine.
Cause Action
Automatic Print Head Alignment has
failed.
See “Auto head align has failed. Press OK and repeat operation. <See
manual>” in “Error Message Is Displayed on the LCD” on page 71.