Filter
Top Products
EdgeFLEX 600 – Release 2.0 1-3
EdgeFLEX 600 Overview
Site Planning
Site Planning
Power Requirements
The EdgeFLEX 600 is available with redundant DC power input connections. The power connectors
are pluggable terminal blocks rated at 41 amps, -40 to -72 VDC, -48 VDC nominal. The maximum
power consumption for an EdgeFLEX 600 device is approximately 675 watts, drawing maximum
16 amps at 40 volts. Maximum current draw (worst case) is 16 amps. Typical power consumption for
an EdgeFLEX 600 (assuming two SCPX cards, plus five of the six POD positions populated) is
approximately 345 watts.
Cooling Requirements
The EdgeFLEX 600 chassis is typically installed in a rack with multiple other devices. To allow for
adequate heat dissipation, the operating environment must provide proper airflow to allow each chassis
to operate at a temperature range of 32° to +122°F (0° to +50°C).
Technical Specifications
Chassis Specifications
The following table lists the chassis specifications for the EdgeFLEX 600 chassis.
Electrical Specifications
The following table lists the electrical specifications for the EdgeFLEX 600.
Specification Value
Height 10.4 inches (264.16 mm, 6 rack units)
Width 17.26 inches (438.4 mm)
Depth 11.8 inches (300 mm). Note: dimensions include cable
requirements.
Weight Approximately 42 lbs. (19 kg), depending on configuration
Mounting 19-inch telco rack, 300mm or 600mm ETSI rack (standard)
23-inch telco rack (optional)
Specification Value
Input voltage (DC) -40 to -72 VDC
Input current 16 amps maximum
DC Power consumption 675 watts maximum, 345 watts typical