Filter
Top Products
EdgeFLEX 600 - Release 2.0 2-7
EdgeFLEX 600 Installation
Installing the Decorative Bezel
Installing the Decorative Bezel
A decorative bezel is included in the Accessory Kit to cover the fan tray and air filter. Snap the bezel
onto the ball stud as shown in the following illustration.
Connecting Power
DANGER! BEFORE INSERTING OR EXTRACTING A EDGEFLEX 600 DC POWER SUPPLY UNIT,
ENSURE THAT THE PSU’S CIRCUIT BREAKER SWITCH IS IN THE OFF POSITION, AND THAT THE DC
POWER CONNECTOR HAS BEEN UNPLUGGED.
Requirements for DC Power Connections
The EdgeFLEX 600 DC model can be powered from a DC supply operating between -40 and -72 VDC.
The power connector is located on the front of the Power Supply Module(s), which are located in the
top two slots of the EdgeFLEX 600 chassis. The PSU modules are redundant and hot-swappable.
Use a separate circuit breaker to power each power supply. This will allow one power supply
to keep the EdgeFLEX 600 operating while the other power supply is powered down for
maintenance.
Use 7 to 8 gauge wire for up to 50 foot run to power the device.
Use a circuit breaker rated for 25 Amps for the power leads.