Filter
Top Products
2-16 EdgeFLEX 600 - Release 2.0
EdgeFLEX 600 Installation
Powering Up and Checking LEDs
Checking System Status LEDs
The EdgeFLEX 600 system status LEDs are located on the SCPX card, the Power Supply Units, and
the Management Card. The following table lists the normal state and alarm state of these LEDs. Refer
to the illustration in Card LED Locations, on page 2-15 for the location of the LEDs.
Check Management Port (Ethernet) LEDs
There are two RJ-45 ports for Ethernet management of the EdgeFLEX 600 located on the Management
card. Refer to the illustration in Card LED Locations, on page 2-15 for the location of the LEDs.
Each Ethernet management port has two status LEDs; LINK/ACT and SPEED. The LINK/ACT LED
is on the right and indicates the presence of an Ethernet link and/or traffic activity on that link. The
LINK SPEED LED is on the left of the port and indicates the speed of the Ethernet link, either 10Mbps
or 100Mbps. The following table lists the interpretation of the states of the two LEDs.
Card/Location LED Label Normal State / Meaning Alarm State / Meaning
Management Card MIN (Minor) Off On (Amber)
MAJ (Major) Off On (Red)
CRI (Critical) Off On (Red)
OMT 1, 2 On (Green) - valid GBIC
module is installed &
recognized
On (Amber) - the GBIC module
cannot be recognized by the
EdgeFLEX 600.
Off - no GBIC installed
ACO Off On (Amber) - When ACO has been
pressed but Alarms are still
present.
SCPX Power On (Green) Off
Active/Standby On (Green) - SCPX is Active
system controller
On (Amber) - SCPX is in Standby
mode
Fault Off On (Red)
Alarm
PSU OK On (Green) Red (PSU not switched on or
no DC supply connected)
PSU - Fan Fault CTRL On (Green) - The fan
controller circuitry on the PSU
is operating properly.
On (Red) - the fan controller on the
PSU is experiencing a fault.
MAIN On (Green) On (Red) - Main Fan Tray has
failed or is not present.
AUX On (Green) On (Red) - Auxiliary Fan Tray has
failed or is not present.
LED Meaning
Link / Activity
(right LED)
On (Green) to indicate Link
Blinking (Green) to indicate Activity
Off to indicate No Link Detected
Speed
(left LED)
Green - 100 Mbps
Amber - 10 Mbps