Filter
Top Products
Using the Setup Menu
21
Using the Setup Menu
Pressing the [MENU] key while an image is being projected displays the setup menu on the
projected image. The setup menu can be used to configure a variety of different projector
settings. The following table shows the menu items that are available in the Setup Menu.
Setup Menu Overview
Main menu Sub-menu Sub-menu Item Type*1
Input source*2
See
page
RCSV –
Image
Adjustment
Brightness Value Setting 31
Contrast Value Setting 31
Sharpness Value Setting 31
Saturation Value Setting 31
Tint Value Setting *4 *431
Color Mode Setting Screen 32
Color Balance Setting Screen 32
Vertical Position Value Setting 34
Horizontal Position Value Setting 34
Frequency Value Setting 34
Phase Value Setting 34
Noise Filter Selection 35
Restore Menu Defaults Execution 35
Volume
Adjustment
Volume Value Setting *335
Restore Menu Defaults Execution 35
Screen
Settings
Vertical Keystone
Correction
Value Setting 36
Horizontal Keystone
Correction
Value Setting 36
Aspect Ratio Selection *537
Resize Image To Fit Selection 38
Projection Mode Selection 39
Ceiling Mount Selection 39
Startup Screen Selection 40
No Signal Screen Selection 40
Mute Screen Selection 41
Restore Menu Defaults Execution 41
*1 This is the sub-menu item type. Refer to the pages noted below for more information.
Value Setting: Specifies a numeric value () page 26).
Selection: Allows selection from multiple options () page 26).
Setting Screen: Numeric value specification or option selection on a separate setting
screen () page 27).
Execution: Initializes a setting () page 28).
Information: Displays information only () page 28).
*2 These columns indicate whether each item appears ( ) or not ( ) for each input
source (R = RGB, C = Component, S = S-VIDEO, V = Video, – = No input signal).
*3 This setting is for the currently selected input source.
*4 This setting can be configured only for an NTSC or NTSC4.43 signal.
*5 This setting can be selected only when the aspect ratio of the input signal is 4:3.