Filter
Top Products
23-20
Catalyst 2960 Switch Software Configuration Guide
78-16881-01
Chapter 23 Configuring SPAN and RSPAN
Configuring SPAN and RSPAN
To delete a SPAN session, use the no monitor session session_number global configuration command.
To remove a destination port from the SPAN session, use the no monitor session session_number
destination interface interface-id global configuration command. To remove the RSPAN VLAN from
the session, use the no monitor session session_number source remote vlan vlan-id.
This example shows how to configure VLAN 901 as the source remote VLAN and port 1 as the
destination interface:
Switch(config)# monitor session 1 source remote vlan 901
Switch(config)# monitor session 1 destination interface gigabitethernet0/1
Switch(config)# end
Creating an RSPAN Destination Session and Configuring Incoming Traffic
Beginning in privileged EXEC mode, follow these steps to create an RSPAN destination session, to
specify the source RSPAN VLAN and the destination port, and to enable incoming traffic on the
destination port for a network security device (such as a Cisco IDS Sensor Appliance).
For details about the keywords not related to incoming traffic, see the “Creating an RSPAN Destination
Session” section on page 23-19. This procedure assumes that the RSPAN VLAN has already
been configured.
Step 8
end Return to privileged EXEC mode.
Step 9
show monitor [session session_number]
show running-config
Verify the configuration.
Step 10
copy running-config startup-config (Optional) Save the configuration in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
no monitor session {session_number | all |
local | remote}
Remove any existing SPAN configuration for the session.
Step 3
monitor session session_number source
remote vlan vlan-id
Specify the RSPAN session and the source RSPAN VLAN.
For session_number, the range is 1 to 66.
For vlan-id, specify the source RSPAN VLAN to monitor.