Filter
Top Products
640 - 607
Leading the way in IT testing and certification tools, www.testking.com
- 100 -
B. Network IP-Address
C. IP address IP-address subnet mask.
D. The exit command from the enable configuration
E. Copy running-configuration to startup-configuration
Answer: C
Explanation: The ip address command is used to start IP processing on a router (in fact the same command is
also used to do the same on a switch.
Incorrect Answers:
A is incorrect; this is not a valid command.
B is incorrect; the network command is most often used to identify directly connected networks.
D is incorrect; this is not a valid command.
E is incorrect; this command will copy the running config to the NVRAM.
Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 245, 133, 277.
Q. 162
When you issue the command show version, your router returns:
“Configuration register is 0x0101”
From where does the router boot?
A. ROM
B. NVRAM
C. FLASH
D. A TFTP server
Answer: A
Explanation: If you want your router to boot automatically from ROM you need to set the boot field to 1 (0x1).
Incorrect Answers:
B is incorrect; to boot from the NVRAM the boot field must be set from the range of 2 to F (0x2 to 0xF).
C is incorrect; to boot from FLASH the boot system flash command would need to be used.
D is incorrect; to boot from a TFTP server the boot system tftp command would need to be used.
Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 127-130.
Q. 163