Filter
Top Products
640 - 607
Leading the way in IT testing and certification tools, www.testking.com
- 60 -
Incorrect Answers:
B is incorrect; the number 10.2.0.0 is the problem for this option
C is incorrect; each network identified must have its own network command.
D is incorrect; this is not correct as there is no need to use the subnet mask for the networks.
Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 277, 285-286.
Q. 90
Which show command should you use to view Frame Relay local management interface (LMI) traffic
statistics?
A. show lmi
B. show ip route
C. show interface
D. show statistics
E. show frame-relay lmi
Answer: E
Explanation: The show frame-relay lmi command displays lmi statistics. An example of one of these statistics
is the number of status messages sent between the local router and the Frame Relay switch.
Incorrect Answers:
A is incorrect; show lmi is not a valid command.
B is incorrect; show ip route command displays the contents of the IP routing table.
C is incorrect; show interface command displays a serial interface configuration
D is incorrect; show statistics is not a valid command.
Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 422-423, 280, and 106.
Q. 91
Which command specifies a second subinterface on serial interface zero?
A. interface s 0.2 point - to point
B. interface 2 s 0 point to point
C. sub interface 2 s 0 point to point
D. interface 0 sub 2 point to point
E. interface s 0.1 point to point sub 2