Filter
Top Products
640 - 607
Leading the way in IT testing and certification tools, www.testking.com
- 35 -
B is incorrect; the show ip route command displays the contents of the ip routing table.
D is incorrect; the show interface command displays the serial interface configuration.
F is incorrect; this is not a valid command.
Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 324-325, 280, and 106
Q. 45
Which of the following commands applies to an access control list to a router interface?
A. permit access-list 101 out
B. ip access-groups 101 out
C. apply access-list 101 out
D. access-class 101 out
E. ip access-list e0 out
Answer: B
Explanation: In order for an access list to be activated the ip-access group command must be used. This
command activates the ip access list on an interface. Before you use the ip-access group command you must
take care to ensure that you have configured an access list. If you do not the result will be permit any.
Incorrect Answers:
A, C-E are not valid commands.
Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) page 305.
Q. 46
Exhibit
Router#show access-list
Extended IP access list 105
deny tcp any 172.30.24.64 0.0.0.63 eq smtp
deny tcp any any eq telnet
Router#show ip interface e0
Ethernet0 is up, line protocol is up
Internet address is 172.17.9.60/24
Broad address is 255.255.255.255
Address determined by setup command
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is enabled
Outgoing access list is 105
Inbound access list is not set
Proxy ARP is enabled