Filter
Top Products
640 - 607
Leading the way in IT testing and certification tools, www.testking.com
- 99 -
Q. 159
Which command displays the interfaces using a given access list?
A. Show filters
B. Show IP interface
C. Show active list
D. Show interface parameters
E. Configure IP access list
F. Show access-list interfaces
Answer: B
Explanation: The show ip interface command displays IP interface information and indicates whether any
access lists are set for a specific interface.
Incorrect Answers:
A and C-F are incorrect; theses are not valid commands.
Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 324.
Q. 160
You have a Frame Relay Link on serial1. Which command displays the Local Management Interface
(LMI), data link connection identifier (DLCI), and bandwidth for that link?
A. show interface serial1
B. show frame-relay serial1
C. show protocol frame-relay serial1
D. show serial1 encapsulation frame-relay
Answer: A
Explanation: The show interfaces command displays statistics for all interfaces configured on the switch.
Incorrect Answers:
B, C and D are incorrect; these are not valid commands.
Steve McQuerry. Interconnecting Cisco Network Devices
. (Cisco Press: 2000) pages 81-81.
Q. 161
When you configure an IP address on a Cisco Router, which command starts the IP processing on the
interface?
A. IP-Space enable