Filter
Top Products
65-14
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 65 Configuring L2TP over IPsec
Configuring L2TP over IPsec
Step 8
tunnel-group name type remote-access
Example:
hostname(config)# tunnel-group sales-tunnel type
remote-access
Creates a connection profile (tunnel group).
Step 9
default-group-policy name
Example:
hostname(config)# tunnel-group DefaultRAGroup
general-attributes
hostname(config-tunnel-general)# default-group-policy
DfltGrpPolicy
Links the name of a group policy to the
connection profile (tunnel group).
Step 10
authentication-server-group server_group [local]
Example:
hostname(config)# tunnel-group DefaultRAGroup
general-attributes
hostname(config-tunnel-general)# authentication-server-group
sales_server LOCAL
Specifies a method to authenticate users
attempting L2TP over IPsec connections,
for the connection profile (tunnel group). If
you are not using the ASA to perform local
authentication, and you want to fallback to
local authentication, add LOCAL to the end
of the command.
Step 11
authentication auth_type
Example:
hostname(config)# tunnel-group name ppp-attributes
hostname(config-ppp)# authentication ms-chap-v1
Specifies the PPP authentication protocol
for the tunnel group. See Table 65-1 for the
types of PPP authencation and their
characteristics.
Step 12
tunnel-group tunnel group name ipsec-attributes
Example:
hostname(config)# tunnel-group DefaultRAGroup
ipsec-attributes
hostname(config-tunnel-ipsec)# ikev1 pre-shared-key cisco123
Sets the pre-shared key for your connection
profile (tunnel group).
Step 13
accounting-server-group aaa_server_group
Example:
hostname(config)# tunnel-group sales_tunnel
general-attributes
hostname(config-tunnel-general)# accounting-server-group
sales_aaa_server
(Optional) Generates a AAA accounting
start and stop record for an L2TP session for
the connection profile (tunnel group).
Step 14
l2tp tunnel hello seconds
Example:
hostname(config)# l2tp tunnel hello 100
Configures the interval (in seconds)
between hello messages. The range is 10
through 300 seconds. The default interval is
60 seconds.
Command Purpose