Filter
Top Products
70-15
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 70 Configuring Network Admission Control
Changing Global NAC Framework Settings
Changing NAC Framework Session Attributes
The ASA provides default settings for the attributes that specify communications between the ASA and
the remote host. These attributes specify the port no. to communicate with posture agents on remote
hosts and the expiration counters that impose limits on the communications with the posture agents.
These attributes, the default settings, and the commands you can enter to change them are as follows:
Command Purpose
Step 1
global
Switches to global configuration mode.
Step 2
eou clientless username username
Example:
hostname(config)# eou clientless username sherlock
hostname(config)# eou clientless password 221B-baker
hostname(config)#
Changes the username used for clientless
authentication.
username must match the username configured on
the Access Control Server to support clientless
hosts. Enter 1 to 64 ASCII characters, excluding
leading and trailing spaces, pound signs (#),
question marks (?), quotation marks ("), asterisks
(*), and angle brackets (< and >).
Changes the username and password for clientless
authentication to sherlock and 221B-baker
respectively. You can specify only the username,
only the password, or both.
Step 3
eou clientless password password
Changes the password used for clientless
authentication.
password must match the password configured on
the Access Control Server to support clientless
hosts. Enter 4 – 32 ASCII characters.
Step 4
(Optional)
no eou clientless username
Example:
hostname(config)# no eou clientless username
hostname(config)#
Changes the username to its default value.
Step 5
(Optional)
no eou clientless password
Example:
hostname(config)# no eou clientless password
hostname(config)#
Changes the password to its default value.