Filter
Top Products
Connect External Network Uplink Cables to Ethernet Switches
10
Cisco BTS 10200 Softswitch Cabling and IRDP Procedures - AXmp Option
OL-4883-02
Step 7 Action: At the CLI prompt, type the following command ‘faults reset’.
Result: The red “alarm” light will turn off on the front of the unit.
Why: This command clears the fault that tripped when the CCPU Net cables were removed. The fault is
a latching fault so it must be reset to clear the alarm.
Step 8 Action: Repeat Step 1 through Step 7 for the remaining host machines.
Connect External Network Uplink Cables to Ethernet Switches
Follow these steps to connect the external network uplink cables to the Ethernet switches:
Step 1 Refer to Figure 1 on page 2 to identify which Cisco 2924M Ethernet Switch is designated Ethernet
Switch A and which is Ethernet Switch B.
Step 2 If your local network documentation calls for gigabit Ethernet, contact Cisco TAC for assistance.
Step 3 If your local network documentation calls for 100 Mb Ethernet, connect the applicable network uplink
cables as listed in Table 1. Ports #21 through 24 are available for this use.
Step 4 After installing the uplink cables, record the necessary information on a copy of Table 1 or similar
document according to local procedures.