Filter
Top Products
Appendix A: Cable Labeling
17
Cisco BTS 10200 Softswitch Cabling and IRDP Procedures - AXmp Option
OL-4883-02
Appendix A: Cable Labeling
Cables are labeled at both ends with the cable numbers listed in Table 1. Follow these steps to create and
attach the labels.
Note As listed in Table 1, some of the cables require labeling and others do not.
Step 1 Make each label by copying the applicable number from Table 1 onto the label. Be sure to duplicate the
number several times onto the label, as shown in Figure 7, to make it easier to read. (If desired, make the
labels for all cables in one print run.)
Step 2 On a work bench or assembly table, position a cable so that one connector is on your left and the cable
goes off to the right. (See Figure 7.)
Step 3 Attach the appropriate label to the cable as shown in Figure 7.
Step 4 Turn the cable around so that the other connector is on your left with the cable going off to the right.
Step 5 Repeat Step 2 and Step 3 for this side of the cable. The completed cable should look like the example
shown in Figure 8.
Step 6 Repeat these steps for all cables in the rack, using the numbers from the cable list (Table 1).
Figure 7 Labeling Specification
Figure 8 Completed Cable Example
1 inch
Surface of connector that is flush
with rear panel when installed.
#16
#16
#16
Multiple rows on label, sufficient
to ensure that label can be read
without need to rotate or twist cable.
54357
#16
#16
#16
Cable
Connector
Label (example)
to match cable list
#16
#16
54358
#16
#16
#16
#16
#16
#16