Filter
Top Products
Enable IRDP
14
Cisco BTS 10200 Softswitch Cabling and IRDP Procedures - AXmp Option
OL-4883-02
Enable IRDP
This section explains how to enable IRDP functionality on the Cisco BTS 10200 Softswitch and on the
network router.
Enable IRDP on the Cisco BTS 10200 Softswitch
Follow these steps to enable IRDP on the Cisco BTS 10200 Softswitch.
Note You should already have the Cisco BTS 10200 Softswitch application software installed on the
system.
Step 1 Log in to EMS Side A as root user.
Step 2 Remove the defaultrouter file from /etc.
Step 3 There should be three default routes in the routing table. Remove all three of these with the following
command:
route delete net default <gateway address>
Step 4 Execute the following command:
/usr/sbin/in.rdisc -s -f
Step 5 Edit S69inet and search and replace for rdisc -s with rdisc -s -f.
Note This will ensure that reboot will enable the irdp daemon.
Step 6 Put the following lines into the S68inet file:
if [ -f /usr/sbin/in.routed ];
then
\mv -f /usr/sbin/in.routed /usr/sbin/in.routed.org
Step 7 Repeat Step 1 through Step 6 for EMS Side B.
Step 8 Repeat Step 1 through Step 6 for CA Side A.
Step 9 Repeat Step 1 through Step 6 for CA Side B.
Enable IRDP on Adjacent Cisco Routers
If you are enabling IRDP on Cisco routers adjacent to the Cisco BTS 10200 Softswitch, follow these
steps. If you have any questions about setup of these routers, contact your system administrator. If you
need additional assistance, contact Cisco TAC.