Filter
Top Products
D14850.02 MX Series Administrator Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved. www.cisco.com
34
Cisco TelePresence MX Series
ADMINISTRATOR GUIDE
Select the preferred connector for the audio out. When the handset is in use the audio out goes
to the handset, and when hanged up the audio out goes to the preferred output connector.
ADMIN
<None/Internal>
None: The default audio output is the internal speaker.
Internal: The audio out goes to the internal loudspeaker. NOTE: Requires the "Audio
InternalSpeaker Mode" to be enabled.
Audio PreferredOutputConnector: Internal
Set the internal loudspeaker mode.
ADMIN
<On/Off>
On: The internal speakers are enabled.
Off: The internal speakers are disabled.
Audio InternalSpeaker Mode: On
Determine whether audio-mute is allowed or not. The default value is True.
ADMIN
<True/InCallOnly>
True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is not
possible to mute the microphone. This is useful when an external telephone service/audio
system is connected via the codec and is to be available when the codec is not in a call.
When set to InCallOnly this will prevent the audio-system from being muted by mistake.
Audio Microphones Mute Enabled: True
Not applicable in this version.
Select the ring tone for incoming calls.
USER
<Marbles/IceCrystals/Polaris/Alert/Discreet/Fantasy/Jazz/
Nordic/Echo/Rhythmic>
Range: Select a tone from the list of ring tones.
Audio SoundsAndAlerts RingTone: Jazz
Sets the ring tone volume for an incoming call.
USER
<0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.
Audio SoundsAndAlerts RingVolume: 50
Set the volume on the handset.
ADMIN
<0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Value 0 = Off.
Audio VolumeHandset: 70
Set the volume on the headset.
ADMIN
<0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Value 0 = Off.
Audio VolumeHeadset: 70
Set the volume on the loudspeaker.
USER
<0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Value 0 = Off.
Audio Volume: 70
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings