Filter
Top Products
D14850.02 MX Series Administrator Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved. www.cisco.com
35
Cisco TelePresence MX Series
ADMINISTRATOR GUIDE
Applies to cameras supporting PowerLine frequency anti-flickering, i.e PrecisionHD 1080p
cameras.
ADMIN
<Auto/50Hz/60Hz>
Auto: Set to Auto to enable power frequency auto detection in the camera.
50Hz: Set to 50 Hz.
60Hz: Set to 60 Hz.
Cameras PowerLine Frequency: Auto
The backlight functionality compensates for light shining directly at the camera (usually the sun
entering the window) to avoid a too dark image from the room.
ADMIN
<On/Off>
On: Turn on the camera backlight.
Off: Turn off the camera backlight.
Cameras Camera 1 Backlight: Off
Set the camera brightness mode.
ADMIN
<Auto/Manual>
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness, e.g. the level of the brightness level
setting will be used for the camera.
Cameras Camera 1 Brightness Mode: Auto
Set the brightness level. NOTE: Requires the Camera Brightness Mode to be set to Manual.
ADMIN
<1..31>
Range: Select a value from 1 to 31.
Cameras Camera 1 Brightness Level: 1
Not applicable in this version.
Set the camera focus mode.
ADMIN
<Auto/Manual>
Auto: When set to Auto the focus will be updated throughout the call. When moving the
camera, the system will use auto focus for a few seconds to set the right focus of the new
camera position. After a few seconds auto focus is turned off to prevent continuous focus
adjustments of the camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
Cameras Camera 1 Focus Mode: Auto
Set the frame rate frequency.
ADMIN
<60Hz/30Hz>
60Hz: Set the frame rate to 60 Hz.
30Hz: Set the frame rate to 30 Hz.
Cameras Camera 1 FrameRate: 30Hz
The Gamma Mode setting enables for gamma corrections. Gamma describes the nonlinear
relationship between image pixels and monitor brightness.
ADMIN
<Auto/Manual>
Auto: Auto is the default and the recommended setting.
Manual: In severe light conditions, you may switch mode to manual and specify explicitly
which gamma table to use by setting the Gamma Level.
Cameras Camera 1 Gamma Mode: Auto
By setting the Gamma Level you can select which gamma correction table to use. This setting
may be useful in difficult lighting conditions, where changes to the brightness setting does not
provide satisfactory results. NOTE: Requires the Gamma Mode to be set to Manual.
ADMIN
<0..7>
Range: Select a value from 0 to 7.
Cameras Camera 1 Gamma Level: 0
Not applicable in this version.
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings