Filter
Top Products
D14850.02 MX Series Administrator Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved. www.cisco.com
45
Cisco TelePresence MX Series
ADMINISTRATOR GUIDE
Set the VLAN voice mode.
ADMIN
<Auto/Manual/Off>
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If
CDP is not available, VLAN is not enabled. The VLAN Voice Mode automatically will be set to
Auto when the GUI is used to set the Provisioning Mode to CUCM.
Manual: The VLAN id is set manually using the Network VLAN Voice VlanId setting. If CDP is
available, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.
Network 1 VLAN Voice Mode: Off
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
ADMIN
<1..4094>
Range: Select a value from 1 to 4094.
Network 1 VLAN Voice VlanId: 1
The Multiway address must be equal to the Conference Factory Alias, as configured on the Video
Communication Server. The Multiway™ conferencing enables video endpoint users to introduce
a 3rd party into an existing call.
Multiway™ can be used in the following situations:
1) When you want to add someone else in to your existing call.
2) When you are called by a 3rd party while already in a call and you want to include that
person in the call.
Requirements: The Codec C20 must be running TC3.0 (or later), Codec C90/C60/C40 must
be running TC4.0 (or later), EX90/EX60/MX200/MX300 must be running TC4.2 (or later), Video
Communication Server (VCS) version X5 (or later) and Codian MCU version 3.1 (or later).
Endpoints invited to join the Multiway™ conference must support the H.323 routeToMC facility
message if in an H.323 call, or SIP REFER message if in a SIP call.
ADMIN
<S: 0, 255>
Format: String with a maximum of 255 characters.
NetworkServices Multiway Address: "h323:multiway@company.com"
Determine the protocol to be used for Multiway calls. NOTE: Requires a restart of the codec.
ADMIN
<Auto/H323/Sip>
Auto: The system will select the protocol for Multiway calls.
H323: The H323 protocol will be used for Multiway calls.
Sip: The SIP protocol will be used for Multiway calls.
NetworkServices Multiway Protocol: Auto
Determine whether the system should be able to place and receive H.323 calls or not. NOTE:
Requires a restart of the codec.
ADMIN
<On/Off>
On: Enable the possibility to place and receive H.323 calls (default).
Off: Disable the possibility to place and receive H.323 calls.
NetworkServices H323 Mode: On
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings