Filter
Top Products
D14850.02 MX Series Administrator Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved. www.cisco.com
37
Cisco TelePresence MX Series
ADMINISTRATOR GUIDE
Determine if the microphones shall be unmuted automatically when all calls are disconnected. In
a meeting room or other shared resources this could be done to prepare the system for the next
user.
ADMIN
<On/Off>
On: Un-mute the microphones after the call is disconnected.
Off: If muted, let the microphones remain muted after the call is disconnected.
Conference 1 MicUnmuteOnDisconnect Mode: On
Determine if there should be an alert on incoming calls.
USER
<On/Off>
On: All incoming calls will be rejected, with no alert. The calling side will receive a busy signal
when trying to call the codec. A message will display on screen, telling that Do not disturb is
turned on, together with an option to turn off the Do not disturb. When turning off the Do not
disturb mode you will see a list of the calls that have been rejected.
Off: The incoming calls will be alerted.
DoNotDisturb Mode: Off
Lets you decide if the remote side (far end) should be allowed to select your video sources and
control your local camera (pan, tilt, zoom).
ADMIN
<On/Off>
On: Allows the far end to be able to select your video sources and control your local camera
(pan, tilt, zoom). You will still be able to control your camera and select your video sources as
normal.
Off: The far end is not allowed to select your video sources or to control your local camera
(pan, tilt, zoom).
Conference 1 FarEndControl Mode: On
Set the far end control (H.224) signal capability mode.
ADMIN
<On/Off>
On: Enable the far end control signal capability.
Off: Disable the far end control signal capability.
Conference 1 FarEndControl SignalCapability: On
Set the conference encryption mode. A padlock with the text "Encryption On" or "Encryption
Off" displays on screen for a few seconds when the conference starts.
ADMIN
<BestEffort/On/Off>
BestEffort: The system will use encryption whenever possible.
> In Point to point calls: If the far end system supports encryption (AES-128), the call will be
encrypted. If not, the call will proceed without encryption.
> In MultiSite calls: In order to have encrypted MultiSite conferences, all sites must support
encryption. If not, the conference will be unencrypted.
On: The system will only allow calls that are encrypted.
Off: The system will not use encryption.
Conference 1 Encryption Mode: BestEffort
Set the Default Call Protocol to be used when placing calls from the system.
ADMIN
<H323/Sip>
H.323: Select H.323 to ensure that calls are set up as H.323 calls.
Sip: Select SIP to ensure that calls are set up as SIP calls.
Conference 1 DefaultCall Protocol: H323
Set the Default Call Rate to be used when placing calls from the system.
ADMIN
<64..6000>
Range: Select a value between 64 and 6000 kbps
Conference 1 DefaultCall Rate: 768
Specify the maximum transmit call rate to be used when placing or receiving calls.
ADMIN
<64..6000>
Range: Select a value between 64 and 6000 kbps.
Conference 1 MaxTransmitCallRate: 6000
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings