Filter
Top Products
Displaying hardware health status
Cisco TelePresence ISDN Gateway 2.1 Online help (Printable format) 97 of 135
Displaying hardware health status
The Health Status displays information about the hardware components of the Cisco TelePresence
ISDN Gateway.
Note: The Worst status seen conditions are those since the last time the unit was restarted.
To reset these values, click Clear. Refer to the table below for assistance in interpreting the
information displayed.
Field
Field description Usage tips
Fans (3201
series only)
Voltages
RTC battery
Displays two possible states:
OK
Out of spec
States indicate both Current status
and Worst status seen conditions.
OK – component is functioning
properly
Out of spec – Check with your
support provider; component
might require service
If the Worst status seen column displays
"Out of spec", but Current status is
"OK", monitor the status regularly to verify
that it was only a temporary condition.
Temperature
Displays three possible states:
OK
Out of spec
Critical
States indicate both Current status
and Worst status seen conditions.
OK – temperature of the ISDN
Gateway is within the appropriate
range
Out of spec – Check the ambient
temperature (should be less than
34 degrees Celsius) and verify
that the air vents are not blocked
Critical – temperature of ISDN
Gateway is too high. An error
also appears in the event log
indicating that the system will
shutdown in 60 seconds if the
condition persists
If the Worst status seen column displays
"Out of spec", but Current status is
"OK", monitor the status regularly to verify
that it was only a temporary condition.