Filter
Top Products
Task 7Using HP OpenView to Create the SNMP Framework
About HP OpenView
Basic Dial NMS Implementation Guide
Describing the advanced capabilities of HPOV is outside the scope of this document. For more
information, go to http://ovweb.external.hp.com/lpe/doc_serv/ and http://www.openview.hp.com
For Cisco IOS SNMP configurations, see the “Task 1—Enabling SNMP in a Cisco IOS Device” section
on page 41.
Verifying the SNMP Configuration
To verify that the HPOV daemons are running and the SNMP configuration is correct, follow these
steps:
Step 1
Start HPOV from the command line by entering the
ovw&
command from the /opt/OV/bin directory:
aurora:/opt/OV/bin ->ovw&
[1] 5079
Step 2
Verify that all the HPOV daemons are running by entering the
ovstatus
command from the root
directory:
aurora:/ ->ovstatus
object manager name: OVsPMD
state: RUNNING
PID: 430
exit status: -
object manager name: ovwdb
state: RUNNING
PID: 431
last message: Initialization complete.
exit status: -
object manager name: ovtrapd
state: RUNNING
PID: 433
last message: Initialization complete.
exit status: -
object manager name: ovactiond
state: RUNNING
PID: 434
last message: Initialization complete.
exit status: -
object manager name: pmd
state: RUNNING
PID: 432
last message: Initialization complete.
exit status: -
object manager name: ovtopmd
state: RUNNING
PID: 435
last message: Connected to native database: "openview".
exit status: -
object manager name: netmon
state: RUNNING
PID: 450
last message: Initialization complete.
exit status: -