Filter
Top Products
Task 7Using HP OpenView to Create the SNMP Framework
About SNMP Demand Polls
&
Basic Dial NMS Implementation Guide
Troubleshooting SNMP and a Demand Poll
If a device is not responding to a demand poll, follow these steps:
Step 1
Poll a different device to see if it responds to SNMP. If the device responds, HPOV is not the problem.
Step 2
Ping the device that is not responding. If the ping works, the devices are communicating.
Note
A firewall in the communication path can block ping and SNMP packets.
Step 3
Verify that the SNMP community strings are correct.
Step 4
Try polling the device from the HPOV command line. For example, enter the commands
snmpwalk
and
snmpget
.
The syntax for the
snmpget
command line is as follows:
snmpget [options] node object-id [object-id]...
Options:
-d dump ASN.1 packet trace
-v version protocol version (1 or 2c)
-c community community string
-p port remote port
-t timeout retransmission timeout (1/10th seconds)
-r retries maximum retransmission attempts
Caution
Overpolling the wrong OIDs overloads CPUs and crashes network devices.
Verifying that SNMP Traps Are Received
Traps appear in the All Events Browser, which reports what is happening in the network. The events are
updated every few seconds. Understanding the severity level of a trap is important. One trap can be
critical; whereas, another trap can be informative.
Other ways to look for traps include:
Using a network analyzer to capture and inspect data on the line.
Using the
snoop
Unix command to sniff the line and inspect data.
To monitor the limits of a network, configure thresholds to set off alarms. For example, set up an alarm
for a CPU that sustains a 98 percent utilization for a specific amount of time.
Common mistakes include:
Setting thresholds too low.
HPOV is in a constant alarm state because you do not understand how to operate or monitor the
dynamics of the equipment.