Filter
Top Products
82 4025083 Rev A
Configure Wireless Settings
Wireless Basic Settings Page Description
Use the following table to configure the basic settings for wireless communication
for the residential gateway. After you make your selections, click Save Settings to
apply your changes or Cancel Changes to cancel.
Section
Field Description
Basic Settings
Wireless Network
Enable or Disable the wireless network.
Wireless Configuration
The default is WPS. Select Wi-Fi Protected Setup to set up your
network using this option. The Wi-Fi Protected Setup feature
automatically configures an encryption-secured, wireless network.
To use Wi-Fi Protected Setup, you must have at least one other
device that supports Wi-Fi Protected Setup in your network. After
you have configured your Wi-Fi Protected Setup devices, you can
manually configure other devices .
See Wi-Fi Protected Setup (WPS) for more information about
using WPS.
Network Mode
Choose one of these options for the network mode:
G only, B/G Mixed, B/G/N Mixed (factory default)
Important: When TKIP authentication only is selected, B/G/N
Mixed network mode is not available.
Radio Band
Select Enabled 2.4 GHz (factory default) or Enabled 5 GHz.
Note: The 5 GHz radio band may not be supported on some
models.
Channel Width
Choose Standard - 20 MHz Channel or Wide 40 MHz Channel.
Standard Channel
Select one of the channels from the drop-down list to correspond
with your network settings. All devices in your wireless network
must broadcast on the same channel in order to communicate. You
can select Auto (factory default) for automatic channel selection.