Filter
Top Products
Send documentation comments to nexus5kdocs@cisco.com.
2-10
Cisco Nexus 5500 Platform and Cisco Nexus 5000 Platform Hardware Installation Guide
OL-15902-02
Chapter 2 Installing the Cisco Nexus 5000 Series Switches
Installing the Switch
To install the switch in a cabinet or rack using the rack-mount kit provided with the switch, follow these
steps:
Step 1 Install the front rack-mount brackets as follows:
a. Position a front rack-mount bracket against the chassis and align the screw holes as shown in
Figure 2-5. Attach the front rack-mount bracket to the chassis with six of the M4 screws.
b. Repeat with the other front rack-mount bracket on the other side of the switch.
Figure 2-5 Attaching the Front Rack-Mount Bracket to the Cisco Nexus 5548 Switch
Step 2 Install the rack-mount guides on the switch as follows:
a. Position one of the rack-mount brackets against the side of the switch and align the screw holes. See
Figure 2-5. Attach the bracket to the switch with two of the flat-head
M4 screws.
b. Repeat with the other rack-mount bracket on the other side of the switch.
Step 3 Attach the slider rails to the rack as shown in Figure 2-6. Use two 12-24 screws or two 10-32 screws,
depending on the rack rail thread type. For racks with square holes, insert the 12-24 cage nuts in position
behind the mounting holes in the slider rails.
a. Repeat with the other slider rail on the other side of the rack.
b. Use the tape measure and level to verify that the rails are horizontal and at the same height.
1
2
3
4
310515
1 Front rack-mount bracket 3 Rack-mount guide
2 Four M4 screws used to attach the front
rack-mount bracket to the chassis
4 Two M4 screws used to attach the rack-mount
guide to the chassis