Filter
Top Products
9-25
Network Processing Engine and Network Services Engine Installation and Configuration
OL-4448-12
Chapter 9 Removing and Installing the NPE or NSE
Removing and Replacing the NPE or NSE
Reconnecting AC-Input Power to the Cisco 7200 Series Router or Cisco 7200 VXR Router
To reconnect AC-input power to a Cisco 7200 series router or Cisco 7200 VXR router, complete the
following steps:
Step 1 At the rear of the router, check that the power switch on the power supply is in the off (O) position.
Figure 9-18 Connecting AC-Input Power to a Cisco 7200 Series Router
Step 2 Slide the cable-retention clip up away from the AC receptacle, and plug in the power cable.
Step 3 Secure the cable in the power supply AC receptacle by sliding the cable-retention clip down until it snaps
around the connector. The cable-retention clip provides strain relief for the AC power cable.
Step 4 Plug the AC power supply cable into the AC power source.
Note For the Cisco 7200 series routers, each AC-input power supply operating at 120 VAC requires a
minimum of 5A service.
We recommend powering the Cisco 7200 series routers from a 120 VAC, 15A receptacle U.S.
(240 VAC, 10A international) at the power source.
Step 5 Repeat Step 1 through Step 4 if a second power supply is installed.
This completes the steps for reconnecting AC-input power to a Cisco 7200 series router or
Cisco
7200 VXR router. Proceed to the “Powering Up the Router” section on page 9-33.
1 Power switch 4 Cable-retention clip
2 AC power cable 5 Handle with hole for nylon cable tie
3 POWER OK LED
84398
1
2
3
54