Filter
Top Products
2-26
Optical Transport Turn-Up and Test Guide
78-14964-01
Chapter 2 Quick Installation Procedures
Installing Cisco ONS 15540 ESPx Hardware
Figure 2-6 shows the cross connect drawer on the Cisco ONS 15540 ESPx.
Figure 2-6 Cross Connect Drawer on the Cisco ONS 15540 ESPx
-
Perform the following procedure to connect through the cross connect drawer.
Step 1 Open the cable storage drawer by pushing the tabs in to release the lock on the drawer.
Step 2 Pull out the cable storage drawer.
Step 3 Lock the drawer in the open position by pushing the lever at the back left of the drawer down in the lock
position.
Step 4 Use the MTP cable installation tool to push the MTP connector of the cable into the adapter on the
mux/demux module until the connector snaps into place.
Step 5 Route the MTP cable down through the cutout holes on the cable management tray on the bottom of the
shelf assembly. Pull the cable out the left side of the tray.
Step 6 Route the MTP cable down through the cable management tray. Pull the cable out the left side of the tray.
Step 7 Route the cable down the left side of the chassis and into the drawer.
Step 8 Continue to route the cable through the drawer around the round cable retainers to the right side.
Step 9 Close the cable storage drawer once you route the cables out of the right side and you unlock the drawer.
Step 10 Open the cross connect drawer appropriate for your system configuration.
Step 11 Flip the latches on the cross connect panel up and use them to pull the panel up.
Step 12 Route the MU breakout end of the cable in through the left side of the drawer.
Step 13 Mount the transition box.
LINECARD
MUX-DEMUX
LINECARD
MUX-DEMUX
LINECARD
MUX-DEMUX
LINECARD
MUX-DEMUX
85394
Blue
Grey
Orange
White
Green
Red
Brown
Black
1 TX
1 RX
2 TX
2 RX
3 TX
3 RX
4 TX
4 RX
1 TX
1 RX
2 TX
2 RX
3 TX
3 RX
4 TX
4 RX