CHAPTER
Preparing for Installation 2-1
2
Preparing for Installation
This chapter describesthe general equipment,safety, andsite preparation requirements forinstalling
PA-E3 port adapters.
• Parts and Tools Required, page 2-1
• Software and Hardware Requirements, page 2-2
• Safety Guidelines, page 2-3
• Compliance Information, page 2-6
Parts and Tools Required
You need the following tools and parts to install a port adapter. If you need additional equipment,
contact a service representative for ordering information.
• PA-E3 serial port adapter and one of the following:
— VIP2-15(=) if you are installing only one PA-E3 port adapter; otherwise, we recommend a
VIP2-40(=) or VIP2-50(=).
— Catalyst RSM/VIP2-15(=) if you are installing only one PA-E3 port adapter; otherwise, we
recommend a Catalyst RSM/VIP2-40(=).
— Cisco 7100 series router with at least one available port adapter slot.
— Cisco 7200 series router with at least one available port adapter slot.
— Cisco uBR7200 series router with at least one available port adapter slot.
• Cisco 75-ohm coaxial serial interface cables. (The PA-E3’s 75-ohm cables are available only
from Cisco Systems; they are not available from outside commercial vendors.)
• Number 1 Phillips screwdriver and a 3/16-inch flat-blade screwdriver (for VIP2 and
Catalyst RSM/VIP2 installation only).
• Your own ESD-prevention equipment or the disposable grounding wrist strap included with all
upgrade kits, field-replaceable units (FRUs), and spares.