Filter
Top Products
VIP2 and the PA-E3 3-7
Installing a Port Adapter
Figure 3-6 Port Adapter Installed in a Port Adapter Slot—Partial Port Adapter View
Step 5 Replace the screw in the rear of the port adapter slot. (See Figure 3-3 for its location.) Do
not overtighten this screw.
Step 6 To reinstall the VIP2 in the system, follow the steps in the section “Installing a VIP2” in
the configuration note Second-Generation Versatile Interface Processor (VIP2)
Installation and Configuration, which shipped with your VIP2.
Step 7 If the interface cables have been disconnected, reconnect the interface cables to the port
adapters.
This completes the procedure for installing a port adapter on a VIP2. Proceed to Chapter 8,
“Configuring the PA-E3 Interfaces,” for information on how to configure your port adapter
interfaces.
H3152