Filter
Top Products
Checking the Configuration
PA-E3 Serial Port Adapter Installation and Configuration
8-16
Following is an example of the show version command used with a Cisco 7500 series system:
router# show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software, Version 11.1(16)CA
Synced to mainline version: 11.1(10.5)
Copyright (c) 1986-1997 by cisco Systems, Inc.
Compiled Thu 22-May-97 14:32
Image text-base: 0x600108E0, data-base: 0x60A00000
ROM: System Bootstrap, Version 5.3.2(3.2) [kmac 3.2], MAINTENANCE INTERIM SOFTWARE
ROM: GS Software, Version 11.1(8)CA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
keats uptime is 22 minutes
System restarted by reload
System image file booted via tftp from 172.16.0.0
Last reset from power-on
G.703/E1 software, Version 1.0.
G.703/JT2 software, Version 1.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
TN3270 Emulation software (copyright 1994 by TGV Inc).
Chassis Interface.
3 VIP2 controllers (1 FastEthernet)(4 Ethernet)(1 Fddi)(2 E3).
4 Ethernet/IEEE 802.3 interfaces.
1 FastEthernet/IEEE 802.3 interface.
2 Serial network interfaces.
1 FDDI network interface.
125K bytes of non-volatile configuration memory.
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2
To determine which type of port adapter is installed in your system, use the show diag slot
command. Specific port adapter information is displayed, as shown in the following example of a
one-port PA-E3 in chassis slot 3 on a Cisco 7200 series router:
router# show diag 3
Slot 3:
E3 PA port adapter, 1 ports
Port adapter is analyzed
Port adapter insertion time 01:04:31 ago
Hardware revision 1.0 Board revision UNKNOWN
Serial number 3710903 Part number 73-1801-03
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 71 01 00 00 38 9F B7 49 07 09 03 00 00 00 00
0x30: 06 00 00 00 FF FF FF 00 FF FF FF FF FF FF FF FF