Filter
Top Products
Checking the Configuration
PA-E3 Serial Port Adapter Installation and Configuration
8-14
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
4084 packets output, 1298712 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
For Cisco 7100, Cisco 7200, and Cisco uBR7200 series routers, use the show controllers serial
command, using arguments such as the slot and port number (slot/port), to display information that
is specific to the serial interface hardware. Following is an example of the show controllers serial
slot/port command that shows the serial port adapter installed on a Cisco 7200 series router in
chassis slot 3:
router# show controllers serial 3/0
M1T-Serial: show controller:
PAS unit 0, subunit 0, f/w version 1-23, rev ID 0x1, version 2
idb = 0x608E3340, ds = 0x608E50C0, ssb=0x608E5A84
Clock mux=0x35, ucmd_ctrl=0x8, port_status=0x25
maxdgram=4474, bufpool=64Kb, 128 particles
TM=down CA=up LC=down
line state: up
Serial DTE cable
(Display text omitted.)
For a VIP2, use the show controllers serial command, using arguments such as those that specify
the slot, port adapter, and port numbers (slot/port-adapter/port), to display information that is
specific to the serial interface hardware. Following is an example of the show controllers serial
slot/port adapter/interface command that shows serial port 2/0/1 on a one-port PA-E3 installed on a
VIP2 in chassis slot 1:
router# show controllers serial 2/0/1
Serial2/0/1
Mx E3(2) HW Revision 0x2, FW Revision 2.42
Framing is g751, Clock Source is Line, Bandwidth limit is 34010.
National Bit is 0, International Bits are: 0 0
DSU mode 0
Data in current interval (421 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation
0 P-bit Err Secs, 0 P-bit Severely Err Secs
0 Severely Err Framing Secs, 0 Unavailable Secs
0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Total Data (last 1 15 minute intervals):
4 Line Code Violations, 0 P-bit Coding Violation,
0 C-bit Coding Violation,
0 P-bit Err Secs, 0 P-bit Severely Err Secs,
0 Severely Err Framing Secs, 0 Unavailable Secs,
3 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
No alarms detected.
(Display text omitted.)