Filter
Top Products
Chapter 5
Configuring the Switch
24
48-Port 10/100 + 4-Port Gigabit Switch with WebView and Power over Ethernet
Event Description A text comment that describes the
entry in the Event Setting Table.
Type The type of action that is taken for an alarm. This
can be None, Log, Trap, or Log and Trap.
Community The SNMP community name that a trap
manager must use to receive trap messages.
Owner The name of the person who created this entry in
the Event Setting Table. (Maximum 127 characters).
Click on the Add button to add an Event index entry to
the table.
To display each time an event was triggered by an alarm,
first highlight an entry in the Event Control Table and
then click on the View Log Table button. The Log Table
shows the log index number, the time of an event, and the
description of the event that activated the entry.
Statistics > Port Utilization
Statistics > Port Utilization
Displays the percentage of bandwidth currently utilized
on each port of the Switch.
Statistics > 802.1x Statistics
Statistics > 802.1x Statistics
The Switch can display statistics for 802.1X protocol
exchanges for any port.
To view the statistics for a port, select the required interface
from the drop-down menu and click Query.
To set a refresh rate for updating the 802.1X statistics,
select a time interval from the Refresh Rate drop-down
menu.
ACL
Access Control Lists (ACL) provide packet filtering for IP
frames (based on address, protocol, Layer 4 protocol port
number or TCP control code) or any frames (based on MAC
address or Ethernet type). To filter incoming packets, first
create an access list, add the required rules, specify a mask
to modify the precedence in which the rules are checked,
and then bind the list to a specific port.