Filter
Top Products
Chapter 5
Configuring the Switch
48
48-Port 10/100 + 4-Port Gigabit Switch with WebView and Power over Ethernet
SNMP > Notification Recipient
SNMP > Notification Recipient
Recipient IP IP address of a new management station to
receive notification messages.
Notification Type Notifications are sent as traps or inform
messages. The informs option is only available for version
2c and 3 hosts. (Default: Traps are used)
SNMPv1,2
Community String Specifies a valid community string
for the new trap manager entry. (Range: 1-32 characters,
case sensitive)
Notification Version Indicates if the user is running
SNMP v1 or v2c. (Default: v1)
SNMPv3
User Name The name of user connecting to the SNMP
agent. (Range: 1-32 characters)
Security Level When trap version 3 is selected, you
must specify one of the following security levels. (Default:
noAuthNoPriv)
noAuthNoPriv
There is no authentication or encryption
used in SNMP communications. (This is the default for
SNMPv3.)
AuthNoPriv
SNMP communications use authentication,
but the data is not encrypted (only available for the SNMPv3
security model).
AuthPriv
SNMP communications use both authentication
and encryption (only available for the SNMPv3 security
model).
•
•
•
UDP Port Specifies the UDP port number used by the
trap manager.
Timeout The number of seconds to wait for an
acknowledgment before resending an inform message.
(Range: 0-2147483647 centiseconds; Default: 1500
centiseconds)
Retry times The maximum number of times to resend
an inform message if the recipient does not acknowledge
receipt. (Range: 0-255; Default: 3)
Admin
The Admin tab provides access to system administration
settings and tools. It includes the following screens:
Admin > User Authentication
Admin > User Authentication
The Switch supports up to 6 user names and passwords
for management access (console and web interfaces).
The default user name is “admin” with no password. You
should therefore assign a new password for the “admin”
user account and store it in a safe place. The default
“admin” account cannot be deleted from the system.
As well as the default “admin” account, up to five other
user-defined accounts can be created on the Switch. To
create a new user account, enter a user name and password
up to eight characters long, confirm the password, and
then click Add.
To change the password for a specific user, select the user
name from the list, enter the new password, confirm the
password by entering it again, and then click Update.