Filter
Top Products
12
Catalyst 6500 Series Switch and Cisco 7600 Series Router CMM Installation and Verification Note
78-14107-07
Installing and Removing the CMM
Figure 6 Clearing the EMI Gasket in a Horizontal Slot Chassis
b. Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create
a small (0.040 inch [1 mm]) gap between the EMI gasket and the module above it. (See Figure 6.)
Caution Pressing down too firmly on the levers will bend and damage them.
c. While pressing down, simultaneously close the left and right ejector levers to fully seat the module
in the backplane connector. The ejector levers are fully closed when they are flush with the module
faceplate. (See Figure 7.)
1
2
3
FAN
STATUS
4
5
6
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1
PORT 2
Switch Load
100%
1%
LINK
LINK
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1
PORT 2
Switch Load
100%
1%
LINK
LINK
1 mm
24 PORT 100FX
WS-X6224
STATUS
ACTIVE
SELECT
NEXT
4
3
5
5
4
6
6
SWITCH FABIRD MDL
WS-C6500-SFM
STATUS
ACTIVE
Gap between the module
EMI gasket and the
module above it
Press down
Press down
58570