Filter
Top Products
13
Catalyst 6500 Series Switch and Cisco 7600 Series Router CMM Installation and Verification Note
78-14107-07
Installing and Removing the CMM
Figure 7 Ejector Lever Closure in a Horizontal Slot Chassis
Note Failure to fully seat the module in the backplane connector can result in error messages.
d. Tighten the two captive installation screws on the module.
Note Make sure that the ejector levers are fully closed before tightening the captive installation
screws.
Vertical slots
a. Position the module in the slot. (See Figure 8.) Make sure that you align the sides of the module
carrier with the slot guides on the top and bottom of the slot.
1
2
3
FAN
STATUS
4
5
6
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1
PORT 2
Switch Load
100%
1%
LINK
LINK
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1
PORT 2
Switch Load
100%
1%
LINK
LINK
SWITCH FABRIC MDL
WS-C6500-SFM
STATUS
ACTIVE
SELECT
NEXT
58571
Ejector levers flush
with module faceplate