Filter
Top Products
2-4
2.4 Printer Setup Mode
The printer enters the printer setup mode when both Pause and Feed keys
are pressed simultaneously. The control key functions at this time are
described below.
Settings of the printer setup mode are stored in nonvolatile memory, so once
they are set, they are remained even when the power is turned off.
[Functions]
Set the print mode selection, peeling sensor ON/OFF, auto-cutter
ON/OFF etc.
Pause key: Selects the mode.
Feed key: Selects the mode item.
Stop key: Saves settings and returns the printer to normal
operating mode.
Item LCD indication
↓
Direct-thermal/thermal Direct TM → Transfer →
transfer printing
↓
Peeling sensor Peel OFF → Peel ON →
↓
Auto-cutter Cut OFF→ Cut ON →
↓
Tearing Tear OFF → Tear ON →
↓
Sensor selection Edge → Reflect → ContinuP →
2.5 Self-Test Mode
The printer enters the self-test mode when the Feed key is pressed and held
down while turning the printer on.
[Functions]
The printer performs the test print and enters the data dump mode (prints
communication data with ASCII codes). The printer returns to the normal
operating mode when the power is turned off.
If the Feed key is pressed further for five seconds after the printer has
entered the self-test mode, the test print will be performed in the continuous
paper mode, regardless of sensor selection stored in backup memory.