Filter
Top Products
3-6
Reference points
The reference points are described in the figure. The position of 2.5
mm from the left edge of the paper is the reference point. The left
bottom is the reference point for the printed characters and bar codes.
The concept of this reference point is common to such commands as
ruled line and graphic.
3.3 Ribbon
Size of ribbon:
Width of ribbon:
25.4–114.3 mm (1–4.5 in). The ±10% of the width of the
paper to be used is recommended for the width of the thermal-transfer
ribbon.
Use the inner diameter of 25.4 mm (1 in) for the ribbon paper core.
The ribbon with inking surface rolled inward or outward can be used.
The maximum outer diameter of the ribbon roll is 74 mm (2.9 in).
A single roll of ribbon (360 m) can be used for printing on about two rolls
with an outer diameter of 203 mm (8 in).
Direction of paper feed
Printing reference point
Printing reference point
Paper reference line
Printing reference point
Printing reference point
2.5
Left edge of paper