Filter
Top Products
6-16
• Parameter initial values
Initial values of print and feed positions are described below.
Unit: mm (inch)
Normal
printing
Auto-
cutter
Peeling Tear-off
Minimum
value
Print position
(Onnnn, form offset)
55.9
(2.2)
55.9
(2.2)
55.9
(2.2)
55.9
(2.2)
12.7
(0.5)
Feed position
(fnnn)
55.9
(2.2)
* *
70.1
(2.8)
12.7
(0.5)
If values lower than the minimum values are set, initial values will be set
instead. (For values with mark*, see the separate option operation
manuals.)
6.5.6 When "fnnn" command is executed while tear-off is OFF
Even with the tear-off ‘OFF,’ the paper will be fed to the "fnnn"-specified
position after printing if an "fnnn > Onnnn" value is set by using the "fnnn"
command.
This function will be used for such case as another device is incorporated in
the printer.
To perform operation with the FARGO, the following may be different from
those in the tear-off ‘ON’:
• The paper is fed immediately after printing, and in the tear-off ‘ON’ the
paper is fed when no data is transmitted for 0.5 second after printing.
However, if the next print data is transmitted during printing, the printer
will start the next printing without feeding or back-feeding.
6.5.7 Priority order
The following three functions (optional) cannot be performed simultaneously.
If commands for these three functions are received simultaneously,
they will be executed in the following priority order:
1st: Auto-cutter
2nd: Peeler
3rd: Tear-off