Filter
Top Products
Chapter 2 Safety Precautions
−
6
−
Avoid high-humidity areas
Do not put the printer in areas with high-humidity or heavy
condensation. If moisture has condensed on the printer, turn off the
power switch immediately and leave the printer for a while until the
moisture dries up. Using the printer when damp may result in electrical
shock.
Carrying
Before carrying the printer, be sure to remove the plug from the outlet
and the connecting cable to the outer equipment. If left connected, the
power cord and connecting cable may be damaged, leading to fire and
electrical shock.
Do not transport the printer while loaded with paper or ribbon. If paper
is loaded, it may drop out, leading to injury or internal damage to the
printer.
When placing the printer on a floor or desk, be careful not to catch your
fingers and hands under the feet of the printer.
Power
Never operate the power switch or insert/remove the power or data
cord with wet fingers. Failure to observe this precaution may result in
electrical shock.
Power cord
Do not put a heater near the power cord. A nearby heater can melt the
power cord casing, resulting in fire or electrical shock.
When removing the plug of the power cord from the outlet, be sure to
grip the plug, not the cord, when pulling it out. Pulling the cord may
expose the core or break the wire, leading to fire or electrical shock.
CAUTION