Filter
Top Products
Chapter 4 Media (Paper) and Ribbon
−
26
−
9. Close the right side cover and then close the front cover, allowing the magnetic catch to firmly hold
the front cover.
The ribbon is now loaded.
NOTE
The following procedure may help you load the ribbon more easily. First insert the bobbins into the
source and destination ribbon cores, affix the adhesive tape at the end of the ribbon and then wind
the ribbon around the bobbin until the tape is hidden. Finally, set the ribbon by passing it through the
lower side of the printhead block.
CAUTION
Be sure to wind the ribbon sufficiently over the adhesive leader (or clear adhesive tape) being
fastened to the end of the ribbon before closing the right side cover.