Filter
Top Products
Chapter 2 Safety Precautions
−
7
−
Opening/closing the right side cover
When opening/closing the right side cover, be careful not to catch your
fingers between the cover and chassis.
When opening, open the cover all the way until it stops at the hinges,
and then release your hand.
When closing, close the cover fully and then release your hand.
Printhead
The printhead remains at a high temperature immediately after printing.
Therefore, be careful to avoid contact with the printhead when
replacing the ribbon or paper or cleaning the printer immediately after
printing. Failure to observe this precaution may result in burning.
The edge of the printhead can injure your bare hands and the
printhead itself can give you an electrical shock. To replace the
printhead, contact our service personnel. Never try replacement by
yourself.
Loading the paper and ribbon
When loading the paper and ribbon, be careful not to catch your fingers
in the mechanism.
No use for long periods
When the printer is not used for long periods, the plug of the power
cord should be removed from the outlet to ensure safety.
Printer care and cleaning
Whilst performing maintenance and cleaning, the plug of the power
cord should be removed from the outlet to ensure safety.
Do not use benzine, thinner, alcohol, etc. to wipe the dirt off the printer.
Failure to do so may cause discoloration or deformation. If the dirt is
too large, soak a cloth in a thin neutral detergent and squeeze out and
wipe with it, and finally wipe with a dry, soft cloth.