Filter
Top Products
20
Printer Preparation
This printer is powered by the accessory battery pack and an AC adaptor. Charge and use the
battery pack after installing it in the printer.
1 Open the battery cover on the
back of the printer as shown in
the figure.
Slide it while lightly pressing the
triangular mark on the cover with your
finger.
2 Check the orientation of the
battery pack, put it in place and
push it in the direction shown
by the arrow.
3 Close the battery cover and
push the part shown by the
arrow.
Be sure that the cover is properly
closed.
Installing the Battery Pack
The battery pack is not charged when it is shipped from our factory. Be sure
to charge it before using it for the first time. (Charging method: Page 21)
Do not use any battery or AC adaptor
other than the specified products.
Danger: If you install a replacement battery pack that is the wrong type,
there is danger of an explosion. When you have finished using a
battery pack, dispose of it as instructed in this manual (page 10).
Battery cover
Triangular mark
Battery cover