Filter
Top Products
8
Safety Instructions
Warning
7 Precautions to be followed when handling the printer
• Do not use the printer if it becomes hot, produces smoke or a strange smell,
etc. as it could start a fire. Immediately switch off the printer and remove both
the AC adaptor and/or battery pack, if installed.
• If any foreign (metal scraps, water, or other fluid) gets inside the printer,
immediately switch off the printer and remove both the AC adaptor and/or
battery pack, if installed. Then contact your service representative.
Failure to do so could result in fire.
• Do not put on an unstable surface as it may fall or topple over causing some
injury.
• Do not use it in any of the following locations, otherwise it will malfunction:
– In a car that is exposed to the sun, in any place exposed to direct sunlight,
near a heater etc.
– In a place where the temperature and humidity are very high or low or where
they fluctuate widely.
– In an extremely dusty place
– In a place exposed to water or other fluid
• Do not drop or hit the printer as doing so will damage it or cause it to
malfunction.
• Keep all foreign material out of the printer. This will cause it to malfunction.
• Do not use a volatile fluid (thinner, benzine, etc.) or wet cloth to clean the
printer. If you do, it will be degraded or discolored. Clean it with a dry soft
cloth.
• During printing or when it is in standby status, do not move, shake or hit the
printer. There is a danger that the power will be cut off, losing printing data.
Precaution