CBM-230/231 User’s Manual
33
CITIZEN
(8) Specifying the bit Image (ESC * m n1 n2 D1 ~ Dn)
Code:[1B]h+[2A]h+m+n1+n2+Dn
* {m= Bit imagemode (refer to the table below)}
{0 ≤ n1 ≤ FF}
{0 ≤ n2 ≤ 02}
The data is described with the hexadecimal code.
Prints the data in the form of bit image in accodance with the bit image mode specified by "m".
• The number of bit printed is divided by 256, and n2 and is assumed to be a quotient, and n1 to be the
remainder.
• The total number of dots printed in the form of bit image is n1 + (256 × n2).
• When the bit image is entered beyond a 1 dot line (576 dots) position, the surplus data is discarded.
• For the bit image data (Dn), the bit to be printed is set to "1" and that not to be printed to "0".
• The following table shows the bit image mode.
( ) = For 42 columns spec.
Vertical Horizontal
m(Hex) Mode
No.of Dots Dot Density Dot Density Max. No. of Dots
0 8-dot single density 8 67 DPI 101 DPI 288 (252)
1 8-dot double density 8 67 DPI 203 DPI 576 (504)
20 24-dot single density 24 203 DPI 101 DPI 288 (252)
21 24-dot double density 24 203 DPI 203 DPI 576 (504)
• When the value set for "m (bit image mode)" dose not meet the condition, the data subsequent to n1 is
processed as printing data.