Filter
Top Products
24
Chapter3
Preparing the Printer
1
2
3
4
5
6
Paper near end sensor
When installed
vertically and
wall hung
When installed horizontally
Change the sensor location according to the way the printer is installed and the interior
diameter of the roll paper you are using. Referring to the following table, set it at a
location suited to the usage environment by moving it to the left and right while pushing
the concave part of the center of the sensor with your finger. (When shipped from the
factory, it is set at φ24mm.)
Setting the Paper Near End Sensor
The remaining roll paper (external diameter of the roll paper) differs greatly
according to the type of roll paper used. Use these values only as guidelines.
When the sensor has detected the remaining roll paper during printing, the printer
stops printing after it has printed all the data that it had received.
If you are using a model with parallel (IEEE1284) interface specifications, you can
select sensor enabled/disabled in Soft SW Setting Mode.
If you are using a model with serial (RS232C) interface specifications, it is always
enabled.
Caution
Installation
method
Remaining roll
paper (mm)
Sensor location
Approx. φ22
Approx. φ24
Approx. φ27
Approx. φ27
Approx. φ24
Approx. φ22
1
Horizontal 2
3
4
Vertical
(wall mounted)
5
6